Descrizione
Mounting Method:
With 12V power voltage: A cable connects 1, another cable connects. 2 and 3
With 24V Voltage: A cable connects 2, another cable connects 3 (1 remain).
Dual power supply. Operate at 12 Volt or 24 Volt. Your can use thinner wires when operating at 24 Volt.
A central mounting hole on the front side to allow for three point mounting. This is much easier for bed leveling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole.
Large solder pads for multiple wires (ribbon cable) or a SMD pinhead connector can be mounted. Pads for SMD thermistor 1206
1 layer 35μm (1oz base) copper
CHARACTERISTICS:
Resistance at 12 Volt setting is between 1.0 and 1.25 Ohm (115~144 Watt)
Resistance at 24 Volt setting is between 4.0 and 5.0 Ohm (144 ~115 Watt)
110 degrees Celsius possible for both 12 Volt and 24 Volt
Running 24 Volt on the 12 Volt terminals will heatup the heatbed to 100 degree in only 2 minutes (will also consume up to 576 Watts!!)
Maximum temperature rating: 180 degree Celsius
Flatness across surface is approximately within +-0.2mm
Material: Allu
Special Function: highback Resistance Point Contact Diode
Function: Darlington triode
Usage: Mixer diode
Structure: NPN
Il nostro MK3 è stato installato con un piatto in alluminio nel processo di creazione del prodotto. Il piatto riscaldato in alluminio spesso 3 mm con un peso proprio offre un’esperienza di stampa del tutto particolare. Presenta dei vantaggi rispetto ad altri materiali.
Il nuovo circuito garantisce un’alimentazione stabile e una tensione di corrente da 12 V o 24 V non costituisce un problema.
Dimensioni complessive del piatto: 214 x 214 x 3 m, superficie riscaldata: 200 x 200 mm, distanza media tra i fori di fissaggio: 209 mm.
Metodo di collegamento: vedi sotto.
